If none of the aforementioned methods managed to spell out success, then it could be the case of bad sectors or corrupt data on your C drive. Now proceed ahead with the setup and verify whether the Windows 11 no device drivers were found error stands Fixed or not.Type in the requested code and hit Enter to verify the changes that you have made to the BIOS. Once done, restart the PC and you should get the Operating System Boot Mode Change prompt.However, If the Secure Boot option is not there, then check for it under the Boot/Authentication/System configuration section and then disable it.Change its state to Disabled and then save the changes. Then go to the Security tab and you should see the Secure Boot option.So start off by booting your PC to the BIOS, as explained above.The only way to verify and hence rectify this issue is to disable this security check (aka Secure Boot). However, in rare instances, it might raise a false positive and could prevent the installation of legitimate drivers as well. Secure Boot is basically a security mechanism put in place by Microsoft that verifies the credibility of each driver that is being installed or loaded at boot time. Check if the Windows 11 no device driver error has been fixed or not. Once done, save the changes and then restart the installation process.You should now see the BIOS xHCI Hand-Off or BIOS EHCI Hand-OFF option, change its state to Enabled.From there, go to the Advanced tab and scroll to the USB Configuration section.Press F10 to select the BIOS menu from there. Then turn it back on, and as soon as it is booting up, continuously press the Esc key. Then click Browse, navigate to the driver files present in the second USB device, and hit OK. Now click OK to close the error message.Once it throws up the “ no device drivers were found” error, connect the second USB device that has the driver file.After that, start off the installation using the primary USB device that has the ISO file.Now transfer the driver files over to this second USB device.Then download the SATA drivers corresponding to your chipset: AMD | Intel.To begin with, create a second bootable USB device using third-party software like Rufus.Windows packs in all the required drivers along with the OS, but as of now, the system is unable to unpack and install these drivers from the ISO file. So your next course of action should be to create a standalone bootable USB device, put in only the drivers there, and then try installing the drivers from that secondary USB. So try out this tweak and then check if it Fixes the Windows 11 no device drivers were found error. Therefore, it is recommended to connect your USB drive to the tried and tested 2.0 port. While the USB 3.0 Port does give a faster read/write speed, however, in some environments, such as in Windows Recovery or BIOS, your system might not be able to identify the device connected to this port. Fix 3: Manually Set the Active Partition.Fix 2: Use a Standalone USB for Drivers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |